MCZ Veld, Использование и установка, Страница: 16 / 25

Chapter 4
USE AND MAINTENANCE MANUAL
page
16
Installation and assembly Technical dept. - All rights reserved by MCZ GROUP S.p.A. - Reproduction
prohibited
The stove must always be handled vertically and only with trolleys. Pay
special attention to the door and its glazing, to protect them from
mechanical knocks which would compromise their good working order.
In all cases, appliances must be handled with care. If possible, unwrap
the stove near the chosen place of installation.
The materials making up the packaging are neither toxic nor harmful,
and so require no particular disposal measures.
Storage, disposal or any recycling is under the responsibility of the end
user in compliance with the applicable laws in force.
4.2. FOOT ASSEMBLY AND ADJUSTMENT
Some models envisage the assembly of support feet, designed to level
the stove so that it is aligned and stable on the floor. The feet are
screwed into the base of the structure, and they can be installed as
illustrated in the figure and adjusted with a screwdriver, inserting it into
the tip of the feet.
4.3. CERAMIC CLADDING ASSEMBLY
The installation of the ceramic parts does not present any particular
difficulties:
Ceramic on ash tray:
1. Remove lever “A” as follows:
remove the black cap at the top of the lever, you will find a
screw inside it; loosen it and remove the lever “A”.
2. Remove the brackets “B”, insert the ceramic part “D” onto the
hook of air adjustment lever “A” and screw the brackets “B”
back on to secure the ceramic in place.
Ceramic on front panel “E”:
1. Loosen the two brackets “C” (left and right) and insert the
ceramic front panel “E” from the top down.
You can now
fit the ceramic sides on :
1. Take the side “F” fitting the pins featured on the side into the
corresponding slots featured at the bottom of the stove
structure. At the top of the ceramic panel, secure the side to
the structure using two screws. Repeat the same steps with the
side G and with sides H-I .
Ceramic top assembly:
1. Rest the cover “L” onto the purpose-provided rubber pads
featured on the stove casing.