PELLET STOVES
Chapter 4
INSTALLATION AND USE MANUAL
page
45
Operation
Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
The code “UT 04” is not part of PROGRAMMED mode.
It is to be used only by the installer or a qualified
technician from MCZ by means of an access key.
Press button 3 again to proceed and to display the
code “UT 05”.
4.10.4.3.
Programme
The POLAR, NOVA and ATHOS stoves can run up to 4 operating
programmes distributed over the course of the day or for the entire
week.
Each programme features three basic steps:
•
The time the stove comes on (it must be between 00:00
and 23:40)
•
The time the stove shuts down (it must be greater than
the start time, up to a maximum 23:50)
•
The days in which the lighting or extinguishing of the
stove must be ACTIVATED or DEACTIVATED
Please look at
PROGRAMME 1
(summarized in the following table). It
is the first of four programmes in the programming sequence.
PROGRAMME 1
Symbol on display
(8)
UT 05
UT 06
UT 07
Data to be inserted
Schedule
Lighting the
stove
Schedule
Shutdown
Days activated or
deactivated
On/Off 1,2,3,4,5,6,7
PROGRAMME 1
: setting of
stove lighting time.
This is step
UT 05. The display
(8)
of the stove panel alternates
between the message
UT 05 and a time value expressed in hours and
minutes. Use the keys
n
(increase) or
o
(decrease) to set the
time
of lighting
of the stove for this programme. Each time the key is
pressed, the time increases or decreases by 10 minutes. If you hold the
key down, the increase or decrease is gradually faster. This lets you
make large changes rapidly. Once you have set the time you want,
memorize it by pressing the key
p
. This will take you automatically to
the next step,
UT 06.
PROGRAMME 1
: setting of
stove shutdown time.
This is step
UT 06. The display
(8)
of the stove panel alternates
between the message
UT 06 and a time value expressed in hours and
minutes. Use the keys
n
(increase) or
o
(decrease) to set the
time
of shutdown
of the stove for this programme. Each time the key is
pressed, the time increases or decreases by 10 minutes. If you hold the
key down, the increase or decrease is gradually faster. This lets you
make large changes rapidly. Once you have set the time you want,
memorize it by pressing the key
p
. This will take you automatically to
the next step,
UT 07.
PROGRAMME 1
: setting of
activated or de-activated days.
This is step
UT 07. The display
(8)
of the stove will alternate between
the code
UT 07 and one of the following: ON 1, OFF 1, ON 2, OFF 2,
Содержание Athos Power HYDRO
Страница 1: ...MANUAL FOR USE AND INSTALLATION...
