
www.mcohome.com User Manual
MCOHome Technology Co., Ltd
2
Cut off any power supply to secure the safety of people and device.
During installation, protect the device from any physical damage by dropping or bumping. If
happens, please contact the supplier for maintenance.
Keep the device away from acid-base and other corrosive solids, liquids, gases, to avoid
damage.
Avoid overexertion during operation, to protect device from mechanical damage.
Read all instructions and documentation and save for future reference.
Installation & Wiring
Location:
Thermostat is suggested to be installed indoor, a place with around 4
1/2
to 5 feet height above
the floor where represents the average room temperature. It should be away from direct sunlight,
any cover, or any heat source, to avoid false signal for temperature control.
CAUTION:
Cut off power supply at circuit breaker or fuse before installation to avoid fire,
shock or death!
Step 1:
Separate the device with a flat-head screwdriver into two parts: the display panel and the
bottom case.
Step 2:
Insert all wires into the right terminals and tighten screws. Wiring diagram is shown below.
Step 3:
Push the bottom case into the junction box and secure it with two screws, and then mount
the touch panel back.
Step 4:
Confirm the device is well mounted, power on and it is ready to operate.
Wiring diagram: