W r a p p i n g M a c h i n e M 2 3 0 - S A N D W I C H
Sec. 1 – General Information
Strada vicinale del campaccio, 1
First release
July 2017 Sec. 1 - Pag. 12
20014
– S. Ilario M.se di Nerviano
Tel: +39 0331 534.754 r.a.
– FAX: +39 0331 534.755
3.2.
L
IGHTING
The machine does not require particular sources of auxiliary lighting as that found in the premises or
in the department where it is placed is sufficient.
REQUIREMENT
The lighting of the work environment must comply with the requirements stipulated in Directive 89/654
EEC. However, it is appropriate for the intensity of diffusion in the area where the machine is placed
not to be less than 300 lux (see UNI EN 12464-1:2004, table 2.7 point 2.7.2).
Ambient lighting must not cause shadows which can cause interference or an irritating glare. In
particular, the light source must be placed behind the work station in order to prevent a glare.
If used in other environments where the ambient lighting is insufficient, a local lighting device must be
installed.
The local lighting must guarantee good visibility in every point, it must not create dangerous reflections
and allow the control panels to be read clearly and the emergency buttons to be identified.
On request, the Work area can be equipped with an additional light source. The maintenance
technicians must use auxiliary lighting to operate inside the electrical panel in order to illuminate better
the internal wiring.
3.3.
A
IRBORNE ACOUSTICAL NOISE EMISSIONS
The machine has been designed so as to minimise noise emission. The value of the M254 Wrapping
machine detected in normal operating conditions is
82 dB
.
REQUIREMENT
The person who will apply the CE mark on the machine is responsible for indicating the value of the
noise emitted by the machine during use.
This value will then be used by the works manager in the company where the machine will be installed
in order to determine the exposure of the operators, as required by the legislation on safety at work
(Title II and Title III of Leg. Decree 81/2008 that implements the requirements of Directive 2003/10/EC.
3.4.
S
UPPORTING SURFACE
REQUIREMENT
The floor must support the weight of the machine described in section 2 paragraph 1.1.2 "Technical
specifications".
The machine must be placed on an evenly level surface to fulfil the stability characteristics.
It is important to make sure that the flooring is adequately consolidated in order to prevent any
subsidence when the machine is installed.
Excessive vibration which could compromise machine operation must be prevented.
However, there must be no vibration on the supporting surface of the machine so as to guarantee
general personal safety and a long life of the components.
