McLelland MAP-1200PRE, Руководство пользователя

Страница: 5 / 26

5
POWER
ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 ZONE 6
MAP-1200PRE
6 SOURCE/6 ZONE MULTIROOM CONTROLLER
FRONT PANEL
REAR PANEL
1. Power ON/OFF/ STANDBY
Depress the power button to turn on the
system. Press it again to release the latch
and power the unit off.
Note that even the Master Controller is
powered on, each zone will remain in
Standby mode until the zone
keypad is activated.
1. PRE-AMP OUTPUT
Stereo Line level output on each zone.
Connect to the input of amplifiers or
powered speakers.
2. SOURCE INPUTS
Source1~3 : RCA Stereo Input
Source4~5: 3.5mm Stereo Input
Source6: OPTICAL Digital Input
3. TRIGGER OUTPUT
When the zone is activated, the
corresponding jack will output 12VDC to
trigger other device.
4. IR EMITTER
IR Outputs to control sources
5. KEYPAD
RJ-45 jack Connects to the keypad hub
for 6 keypads.
6. MASTER/SLAVE SWITCH
Set the unit ID when connecting multi
Controller systems
2.Standby/Zone ON LED
These six LEDs illuminate to indicate the
status of each zone.
Blue: In Standby mode.
White: In Activate mode.
Blue/White: In Mute mode.
1 2
1 2 3 4 5
6
7 8
10
12 11
9
7. AGC
Automatic Gain Control, brings low level up to a
present-level.
8. ETHERNET/RS232 SWITCH
ETHERNET: When the amplifier connects to
Ethernet.
RS232: When the amplifier control by PC or
Control Device via RS-232 port.
9. ETHERNET PORTS
Dual LAN ports, one connects to the LAN port of
local router. Another connects to network
TV or other device which requires Ethernet.
10. RESET
The RESET button is used to reset the
ETHERNET back to factory default settings.
11. EXPANSION IN/OUT PORT
Expandable to 18 zones with 3 x Multi-zone
Controller systems.
12. DC INPUT
Connect the supplied DC adapter to the DC IN
jack, and then plug it into a standard household
outlet