McIntosh MX160, Руководство пользователя

Страница: 28 / 44

28
Figure XX
The Room Perfect Measure and Adjustment Process
uses multiple measurement locations in the listening
room to achieve the best possible acoustical results.
The Focus Position (location in the room) is typically
where one would be during serious viewing/listening.
Refer to figure 20. The Room Positions are other loca-
tions in the room where noncritical viewing/listening
occurs.
Notes: 1. Assemble the supplied Microphone Holder/
Stand/Boom Adapter and connect the Micro-
phone to the MX160 MICROPHONE Con-
nector on the Rear Panel using the supplied
cable.
2. Set the trim controls on the MX160 to the
flat setting position and the volume control
to a normal listening volume level.
3. It might be advisable to temporarily switch
off the room/house heating/cooling system
RoomPerfect
Note: When the RoomPerfect Calibration has been
completed, the MX160 Front Panel “ROOMPER-
FECT” indicator will be illuminated.
while the Room Perfect measurement pro-
cess is occurring. If there are open windows,
they should all be closed. All of these steps
will allow lower testing volume levels and
more accurate measurements.
4. While performing the following steps, refer
to the MX160 Separate Sheets Menu 3 and 4,
“Speaker and Room Menu - Part #1 and #2”
along with the various On-Screen Menus
illustrated.
5. The next time RoomPerfect is run, some of
the On-Screen Menus will have changed to
reflect the already stored settings.
Before starting the “Room Perfect Measurement and
Adjustment Process”, it is very important to have
performed the Speaker and Room “Speaker Setup Edit
Configuration and Verify Speakers”. Refer to pages 20
thru 22.
1. Press the SETUP Push-button to enter the
Setup Mode. Use the Down
▼
Push-button to
highlight Speaker and room Setup, then press
the Directional
►
Push-button.
2. Use the Directional
►
Push-button to select
“Room Perfect”.
3. If the previous measured distances from each
of the Loudspeaker Positions to the “Focus
Position” were not saved, re-enter them now.
4. Select “Run RoomPerfect
TM
setup”.
5. Follow the On-Screen instructions and reposi-
tion the microphone to the necessary measure-
ment locations. Refer to figures 21, 22 and 23.
Note: The Microphone Stand Boom Adapter
allows the microphone to be placed over
objects such as a chair or table.
6. When Room Perfect has completed its Mea-
surement and Adjustments, press the SETUP
Push-button to exit.
Setup Mode, con’t
Figure 20
Focus
Position
Distance between the Loudspeakers (at Ear Level)
and the Microphone Focus Position
Figure 21
Figure 22
Figure 23