McIntosh MCLK12, Руководство пользователя

Страница: 7 / 16

7
The MCLK12 Analog Clock is designed to be placed
upright on a table or shelf, standing on its feet. It may
also be wall mounted.
The clock produces very little heat of its own.
However, it is advisable not to install the MCLK12
directly above a heat generating device. Cool opera-
tion ensures the longest possible operating life for any
electronic instrument.
Wall Mounting
The MCLK12 is supplied with two Wall Anchors for
mounting the clock on a wall. The Wall Anchors will
accommodate wall thickness ranging from 1/8 inch
(0.318 cm) to 5/8 inch (1.59 cm) thick (typical residen -
tial drywall construction). Refer to figure 2. Addi -
tional wall fasteners may be needed when the wall
thickness is greater then 5/8 of an inch or with other
types of wall construction. It is recommended that the
Professionals at your McIntosh Dealer, who are skilled
in all aspects of installation and operation, install the
MCLK12 Analog Clock and any associated audio/
video equipment.
1. Use the supplied MCLK12 Mounting Template
sheet (drawn actual size) to determine the clock’s
location on the wall. Refer to figure 1.
2. Temporarily tape the Mounting Template to the
wall in the desired location.
3. Before performing step 4, make certain there is
no plumbing, electrical wires, electronic cables or
any heating/cooling duct
work located in the wall
behind where the clock
will be mounted.
4. Using a drill equipped
with a 3/8 inch (9.5 mm)
drill bit, drill two holes
into the drywall as indicated on the Mounting
Template. Refer to figures 1 and 3.
5. Remove the Mounting Template from the wall.
6. Locate the two supplied Wall Anchors and insert
them into the just drilled openings in the wall.
Refer to figures 2 and 4.
7. Using a suitable tool,
lightly tap the Wall
Anchors until the anti-
rotation tabs are into the drywall.
8. Using a suitable tool,
rotate the screw head
clockwise of the Wall
Anchors until it starts to
tighten up. It will take
many turns. Refer to
figures 5, 6 and 7.
9. Now rotate the screw of
the Wall Anchor coun-
terclockwise about 6 and
one half turns.
10. Try placing the MCLK12
on the wall by lining up
the rear panel openings of
the clock with the screw
heads of the Wall Anchors. If necessary adjust the
Wall Anchor screws.
11. Proceed to the MCLK12 Rear Panel Connections
on page 8.
Dimensions and Installation
Installation
Center Line
Distance between mounting hole centers, 12” (30.48cm)
MCLK12 Front and Rear Panels shown actual size
+ +
8-3/4”
22.23cm
2-
1/16”
5.24cm
1-
3/4”
4.45cm
Center Line
1-
3/4”
4.45cm
2-
13/16”
7.14cm
2-
9/16
”
6.51cm
Rear Panel
Mounting
Opening
Rear Panel
Mounting
Opening
Figure 1
Figure 2
Dry
Wall
Drill
Bit
Figure 3
Dry
Wall
Wall
Anchor
Anti-Rotate
Tabs
Figure 4
Figure 5
Figure 6
Figure 7