11
Input Setup
You have the ability to control which inputs appear on
the display when you rotate the Input (Right) Knob.
If you wish to remove an unused input or restore a
previously removed input:
• Push and release the Left Knob to enter Setup
• Rotate the Left Knob until the VFD displays
“Inputs (Hold)”
• Press and Hold the Left Knob for two seconds.
“CD PLAYER” will appear in the VFD
• Rotate the Left Knob to select the input you
wish to display or hide
•
Rotate the Right Knob to select On or Off
• Press and release the Left Knob twice to exit the
Setup Menu
Baud Rate Setup
The MCD12000 can be controlled remotely via the
RS232 Jack. The settings for serial communications
are:
• 8 bit, No parity and 1 stop bit
The speed can be adjusted from the Setup Menu.
To adjust the BAUD rate, enter the Setup Menu.
Rotate the Left Knob until you reach “BAUD: …”
Rotate the Right Knob to select from the following
options:
• 9600, 19200, 38400, 57600, and 115200
(default).
Factory Reset
Use the FACTORY RESET option if you wish to
return all settings to factory defaults. All previous
setup changes will be lost.
To Factory reset the MCD12000, enter the Setup
Menu. Rotate the Left Knob until “FACTORY
RESET” appears on the display. Hold the Left Knob
down until “In Progress” appears on the screen. When
the Factory reset is complete, the MCD12000 will
power off.
Playing/Navigating a Disc
• Rotate the Right Knob (INPUT) until CD
PLAYER appears on the Display
• Press and release the OPEN/CLOSE button to
open the tray
• Place the disc, label side up, on the tray
• Press and release the OPEN/CLOSE button to
close the tray
• “Reading” will appear on the Display followed
by Disc information
• You may press the BACK and NEXT buttons to
pick a particular track
• Press and release the PLAY/PAUSE button to
Play; press again to Pause
Additional commands are available on the Remote
Control. See “Navigating the Remote Control” on
Page 14.
The
Program Playback
feature allows the playback of
selected tracks in a chosen order. To use this feature,
Press the SHIFT button on the Remote Control and
then press the RANDOM button twice. Use the
numeric buttons to enter the desired tracks. Press the
PLAY button to begin playing the programmed tracks.
Navigating CD-ROMs
The Remote Control buttons 2, 4, 6 and 8 can be used
for navigating up, down, left, right through tracks/
folders on a CD-ROM. The 5 button can be used
to Enter the folder or Play the track shown on the
Display. For navigating data discs, please see Page 12.
