McIntosh MC7108, Руководство пользователя

Страница: 10 / 26

REAR PANEL
AND HOW
TO MAKE
CONNECTIONS
CONTROL IN connector from the POWER CONTROL OUT connector on compatible Mcln-
tosh products. The MC7108 POWER CONTROL OUT jack will feed the same AC power con-
trol signal out, delayed 0.2 seconds, to turn on and off another accessory component with
a compatible Power Control input.
The MC7108 POWER switch must be in the OFF/REMOTE setting for the power control
signals to turn the MC7108 On and Off.
The POWER CONTROL connectors are standard 1/8 inch mini phone plugs. Only the tip
and sleeve are used for connecting the plug to a single conductor shielded cable.
10. CHANNELS 3 and 4, IN - OUT
BRIDGED: Connect a cable from a Preamplifier or Control Center to 3 IN.
STEREO: Connect cables from the stereo outputs of a Preamplifier, Control Center or other
accessory component to 3 IN and 4 IN.
MONO: Connect cables from the stereo outputs of a Preamplifier or Control Center to 3
IN and 4 IN. The stereo signals will be combined to Mono and fed to each amplifier channel.
The two LEVEL controls will work separately on each channel.
The OUT jacks provide a convenient connection to feed the same signals to other chan-
nels on the MC7108, or to any accessory component.
11. LEVEL (BRIDGED, STEREO and MONO)
BRIDGED: Use only the 3 BRIDGED LEVEL control and adjust as desired.
STEREO: Adjust the individual 3 and 4 LEVEL controls as desired. The 2.5V setting is sug-
gested when the MC7108 is being used with a Mclntosh Preamplifier or Control Center.
MONO: Adjust the individual 3 and 4 LEVEL controls as desired. The combined 3 and 4
Mono signals will be reproduced by each channel.
12. MODE (BRIDGED, STEREO and MONO)
Set the MODE switch to the position for the desired operating configuration.
13. CHANNELS 1 and 2, IN - OUT
BRIDGED: Connect a cable from a Preamplifier or Control Center to 1 IN.
STEREO: Connect cables from the stereo outputs of a Preamplifier, Control Center or other
accessory component to 1 IN and 2 IN.
MONO: Connect cables from the stereo outputs of a Preamplifier or Control Center to 1
IN and 2 IN. The stereo signals will be combined to Mono and fed to each amplifier channel.
The two LEVEL controls will work separately on each channel.
The OUT jacks provide a convenient connection to feed the same signals to other chan-
nels on the MC7108, or to any accessory component,
14. LEVEL (BRIDGED, STEREO and MONO)
BRIDGED: Use only the 1 BRIDGED LEVEL control and adjust as desired.
STEREO: Adjust the individual 1 and 2 LEVEL controls as desired. The 2.5V setting is sug-
gested when the MC7108 is being used with a Mclntosh Preamplifier or Control Center.
MONO: Adjust the individual 1 and 2 LEVEL controls as desired. The combined 1 and 2
Mono signals will be reproduced by each channel.
15. MODE (BRIDGED, STEREO and MONO)
Set the MODE switch to the position for the desired operating configuration.
8