McIntosh MC7108, Руководство пользователя

Страница: 9 / 26

3. LEVEL (BRIDGED, STEREO and MONO)
BRIDGED; Use only the 7 BRIDGED LEVEL control and adjust as desired.
STEREO: Adjust the individual 7 and 8 LEVEL controls as desired. The 2.5V setting is sug-
gested when the MC7108 is being used with a Mclntosh Preamplifier or Control Center.
MONO: Adjust the individual 7 and 8 LEVEL controls as desired. The combined 7 and 8
Mono signals will be reproduced by each channel.
4. MODE (BRIDGED, STEREO and MONO)
Set the MODE switch to the position for the desired operating configuration.
5. CHANNELS 5 and 6, IN - OUT
BRIDGED: Connect a cable from a Preamplifier or Control Center to 5 IN.
STEREO: Connect cables from the stereo outputs of a Preamplifier, Control Center or other
accessory component to 5 IN and 6 IN.
MONO: Connect cables from the stereo outputs of a Preamplifier or Control Center to 5
IN and 6 IN. The stereo signals will be combined to Mono and fed to each amplifier channel.
The two LEVEL controls will work separately on each channel.
The OUT jacks provide a convenient connection to feed the same signals to other chan-
nels on the MC7108, or to any accessory component.
6. LEVEL (BRIDGED, STEREO and MONO)
BRIDGED: Use only the 5 BRIDGED LEVEL control and adjust as desired.
STEREO: Adjust the individual 5 and 6 LEVEL controls as desired. The 2.5V setting is sug-
gested when the MC7108 is being used with a Mclntosh Preamplifier or Control Center.
MONO: Adjust the individual 5 and 6 LEVEL controls as desired. The combined 5 and 6
Mono signals will be reproduced by each channel.
7. MODE (BRIDGED, STEREO and MONO)
Set the MODE switch to the position for the desired operating configuration.
8. 8 CHANNEL IN
This connector will accept the outputs of the six audio channels of a Mclntosh C39 or
MX 130 A/V Control Center for use in a Mclntosh Home Theater System. Use a male-to-female
25 conductor subminiature " D " (D825) shielded computer type cable from the 8 CHANNEL
connector to the 25 pin 6 CHANNEL connector on a Mclntosh C39 or MX130. The six separate
outputs from the Control Centers will appear at the MC7108 in the following channel alloca-
tion. A power control signal to turn the MC7108 power on and off is also sent on the cable
from the Control Center.
CHANNEL 1: Center Front
CHANNEL 2: Left Surround
CHANNEL 3: Left Front
CHANNEL 4: Right Front
CHANNEL 5: Subwoofer
CHANNEL 6: Right Surround
Connect discrete cables from a C39 or MX130 Area " B " OUTPUTS to channels 7 and
8 to drive loudspeakers in the remote Area " B " .
9. POWER CONTROL, IN/OUT
The MC7108 AC power can be turned on and off by a control signal fed to the POWER
REAR PANEL
AND HOW
TO MAKE
CONNECTIONS
7