17
How to Operate the HR033
How to Operate HR033
Video
Press any of the four video signal source push-buttons to
turn the zone on and select the video signal source for use.
CD/Tape
When a CD Player or Tape Recorder is selected, the fol-
lowing operations are possible. Stop, Back Track, Next
Track, and
Play
.
Home
Press the Home push-button, and within 5 seconds, the ap-
propriate number push-buttons (0 through 9) to operate the
optional HC-1 Home Controller which in turn will control
power to accessories.
Sys Off
Press Sys Off (System Off), to turn off the entire McIntosh
Audio/Video system. (This function is not possible in a
zone that has been programmed for a priority Accessory
Control lockout.)
Power
Press Power to turn on the zone where the Remote Control
is located.
Acc On / Acc Off
Press the Acc On push-button to turn power on of an
source component connected to the CR12 System and pro-
grammed. If a McIntosh Remote Control Translator is con-
nected, press the Acc Off. to turn power Off of an acces-
sory component connected to the CR12 System.
CD2, Tuner, PH/Aux and Tape 1
Press any of these push-buttons to select the desired audio
signal source.
0 through 9 Push-buttons
Press one or more numbered push-buttons for any function
requiring direct number key access. This could be operat-
ing the HC-1 Home Controller, accessing tuner station pre-
sets, accessing tracks on a McIntosh MCD7009 CD Player,
MLD7020 Laser Video Disc Player, or any similar function
requiring direct key access. These push-buttons also can be
used to operate accessory components interconnected with
a McIntosh Remote Control Translator.
Tuner Push-buttons
Use with a McIntosh tuner. Select AM or FM broadcast
band. Press and release SEEK Up or Down to move from
station to station. Press and hold a SEEK push-button to
move continuously from station to station. Press REVIEW
to start the automatic brief audition of each of the presets
stored in the tuner memory. Press REVIEW a second time
to stop on a station preset and exit the Review process.
E (Enter)
Press E (Enter) to activate a programming process required
by an accessory component connected to the CR12 with a
McIntosh Remote Control Translator.
Mute
Press Mute to silence or mute audio in any zone where the
Remote Control is being used. Press Mute again, adjust the
main volume or switch to a different signal source to
unmute.
Volume Up or Down
Press these push-buttons to raise or lower volume in any
zone where the remote control is being used.
Note: Remote Control Push-button Additional Functions when a
McIntosh MCD7009 or MLD720 is being used:
CR12 Push-Button MCD7009 Function MLD7020 Function
Review
+10
+10
Seek Down
REVerse
REVerse
Seek Up
FF (Fast Forward)
FF (Fast Forward)
E (Enter)
Pause
Pause
AM
Side A
FM
Side B
ACC On
Power
