McHale
991 High Speed
Round Bale Wrapper
46
Infrared remote
Whenever an Infrared remote type is being used, select IR/WIRED in the Remote Type
Menu, as above. Connect the receiver to the serial port on the electronic control box
and select Auto mode (Button 13). The cycle can be started by pointing the infrared
remote at the receiver and pressing the Auto Start Button. The Emergency Stop Button
will stop the cycle at any time. The other two buttons will rotate the table in forward and
reverse.
Radio remote
Whenever a radio remote is being used for the first time, the remote frequency code
must be “learned” by the electronic control box. Select “RF LEARN” in the Remote
Type Menu and connect the receiver to the serial port on the electronic control box and
select Auto mode (Button 13). Press the Stop Button on the radio remote. A code will
appear on the screen of the electronic control box to show that the radio frequency
code has been stored. ESC (Button 2) can then be pressed to return to the working
screen and the remote is ready to use.
This procedure only needs to be followed when the remote handpiece is used with an
electronic control box for the first time. The “RF” type will be automatically used once
the remote frequency code has been established. Up to 7 handpieces can be
programmed into the one electronic control box, if desired. Each remote handpiece has
a different code which ensures that multiple wrappers can operate in the same location,
without interfering with each other.
.
Infrared receiver
Infrared remote
CAUTION: Press the safety button on the radio remote
simultaneously with all function buttons, except for Stop
There is a safety button located on the back of the remote which needs
to be pressed simultaneously with each function button to activate it.
This safety button doesn’t need to be used for the Stop Button.
Starts Auto cycle/
Starts Auto tip
Emergency
stop
Table
forward
rotate
Table
reverse
rotate