4
3
5
6
1
2
Agile 4250 O & M Manual Iss-01
10.
Moving the building
Step 5/ Replace the Anchors -
Once the building has been successfully moved, install auger anchors and
skid pins. To install the skid pins, pass the pins through the holes in the skids and hammer into the ground.
The holes in the skids pass through at an angle so that the pins can be safely hammered through. To install
the auger anchors, insert the tip of the anchor through the ring on the auger bracket and wind into the ground
using a metal bar passed through the box section on top of the anchor. Wind the anchor down until the cross
bar makes contact with the auger bracket.
Step 6/ Remove the tow bar and reset the drag flaps -
Check underneath the raised floor to ensure the
floor supports are hanging in the correct position (vertically). The floor supports can be hanging but must be
able to reach the ground below to provide their intended support. Finally remove the tow bar, lower the drag
flaps and use the drop bolt to latch them shut.
REMOVE
CHAIN
ANCHOR PIN
AUGER BRACKET
AUGER ANCHOR
STEEL BAR
DROP BOLT
FLOOR SUPPORT
