McFarlane WDL-2100, Руководство оператора и инструкции по настройке, Страница: 28 / 57

28
4. Attach the lights to the mounting brackets using 1/4 x 1 bolts, lock washers and hex nuts.
5. Attach the light assemblies to the last lift arm on the wings using the 3/8 x 2 - 3 3/4 U-bolts and
locking hex nuts. Dimension from the front of the Light Bracket to the front of the lift arm tube
is approx. 16 inches. Do not tighten yet. You may have to adjust the location later. The lights
must be attached so that the red and yellow lenses will be facing away from the center of the unit
with the yellow light towards the rear of the unit. The single yellow lens will be towards the rear,
facing towards the center of the unit. Connect the free end of the wishbone to the lights.
Figure 26
6. Now that the lights have been mounted and the wires run, attach wire harnesses to the lift arms
and hydraulic hoses with zip ties. Be sure to leave slack at the hinge points to prevent the wire
harness from becoming entangled. Also, securely attach the wire harness to the lift arm and next
to the light assembly.
7. Tighten the light assemblies to the lift arms.
8. Check to make sure that all the plugs are properly and securely connected and the wire harnesses
will not become entangled during operation or when the unit is folded into transport position.
Figure 27