McFarlane WDL-2100, Руководство оператора и инструкции по настройке, Страница: 17 / 57

17
Attach the Wings to the Center Bar
1. Attach the hinge knuckles to the center bar. Use 1 3/4” diameter hinge knuckle pins, 5/8” x 4”
grade 5 bolts, and locking hex nuts. Refer to Figure 7.
2. Attach the wings to the hinge knuckles using the remaining 1 3/4” diameter hinge knuckle pins,
5/8” x 4” grade 5 bolts, and locking hex nuts. The wing axle end plate should be offset towards
the front of the unit as shown in figure 7.
*NOTE: Be sure the wings are orientated correctly. Both wings are marked left hand and right
hand and a visual reference can be made by looking at Figure 7 and 8.
Figure 7
Attach the Wing Wheels and Tiebar Bracket
1. Mount the Tiebar Brackets to the wing tube between the cylinder post and the wing/transport
wheel assemblies as shown in Figure 8. Use two 1/2 x 7 x 8 U -bolts, and locking hex nuts. The
location of these brackets should be the same on the right and left hand wing tubes.
Figure 8