MCE Technologies Desktop Internal DVD-R/RW and CD-R/RW Drive, Руководство по установке

Страница: 5 / 8

MCE Desktop Internal DVD-R/RW and CD-R/RW Drive 3
Step 6: Slide the metal shield
away from the optical drive cage.
Step 7:
Remove the power and
ribbon cables from the optical
drive.
Step 8: Unscrew the two attach-
ment screws from the optical
drive cage.
Step 9:
Using two hands, slide the cage back until it disengages from the
chassis and then out to remove it from the computer. Lay the cage aside.
Step 10:
If another drive, such as the original internal CD/DVD-ROM
drive, is going to be on the same data cable as the MCE drive, then make
sure that one drive on the cable is set to the “master”setting and that the
other is set to the “slave” setting. Typically the last drive on the cable is
set to master.
Setting the drives to master or slave is accomplished by sliding a small
plastic “jumper” onto the appropriate pair of pins on
the back of the drive. The purpose of the jumper is to
bridge the gap between two given pins to activate the
desired setting. The relevant three pairs of pins are
usually located near the IDE cable connector on the back
of the drive (see graphic on the next page) and may be labeled
jumper