McCulloch MC1375-AU, Руководство пользователя, Страница: 9 / 13

16 | ENGLISH ENGLISH | 17
GENERAL OPERATION
NOTE: Be sure that Reservoir has been filled and that all desired accessories are
connected before following these steps.
1.
For first time use, remove protective plastic cover from electrical plug. Plug power cord into
an electrical outlet.
2. Switch Lighted On/Off Switch to “On” position.
3. The pressure gauge indicates the operating pressure of the steam cleaner. Once the needle is
in the green section, the unit is ready to begin steaming.
During use and as steam is released, pressure will drop. This may cause the needle to move
down in the green section. This is a normal condition. As long as the needle is in the green
section, the product is operating normally. If the needle is continuously in the yellow or red
section, please contact Consumer Service at 1800 099 012.
4. Direct Nozzle (and any connected accessory) towards surface you desire to steam, and press
Steam Trigger. To sanitize surfaces, point Nozzle, press Trigger and hold approximately 1/2 inch
from surface for at least 5 seconds. This will insure that you have killed germs and bacteria.
CAUTION: Always be sure that Nozzle and any accessory are pointed in a safe direction
(away from yourself, other people, pets, and plants) before pressing Steam Trigger.
5.
Keep Steam Trigger pressed for a continuous flow of steam. This will allow a continuous flow
of steam without need of holding the Steam Trigger down manually. Steam output can be
adjusted by simply turning the Steam Adjustment Knob.
6. Using a back-and-forth motion over the area you are steaming will further enhance the
cleaning process. Wipe steamed areas with a clean cloth to remove loosened dirt and grime.
Wiping the area while it is still wet is recommended, but use caution when wiping surfaces such as
metal that may still be hot.
7. Once steaming tasks are complete, turn the unit “Off” and unplug. Follow steps under Proper
Storage procedure on Page 18 of this manual.
Using Your Canister Steam System Using Your Canister Steam System
STEAM MOPPING
NOTE: Be sure that Reservoir has been filled and that all steam mopping accessories are
connected before following these steps.
It is recommended to sweep or vacuum hard floors before mopping.
1. Follow Steps 1-3 of General Operation section above.
Refer to Page 9 for a listing of hard floor surfaces that are recommended for cleaning
with the Canister Steam System.
2.
For best results, use a continuous back-and-forth motion over floor surface, pushing the Mop
Head away and pulling it back towards you. Work your way backwards over the floor, in order
to avoid walking over freshly mopped areas.
NOTE: To avoid warping or damage caused by heat and moisture, do not use on
unsealed hardwood or unglazed ceramic surfaces. Steam may remove the sheen from
some floors that have been treated with wax.
3.
The Microfiber Pad will absorb dirt and moisture during mopping. However, when you
are finished you may find some residual moisture has been left behind. In this case, it is
recommended to allow floor time to air-dry. A fan may be directed towards mopped area to
facilitate drying.