38
// Status
Display
/B[0|1|2]
RS-232 Baud Rate Control (0=19.2, 1=57.6, 2=115.2KHz)
/C
Close I2C Connection
/Dxx
Set Destination I2C Slave Address
/E[0|1]
Echo/Prompt Control (0=Disable, 1=Enable)
/F[0|1]
Flow Control (0=XON/XOFF, 1=RTS/CTS)
/G[0|1]
General Call Control (0=Disable, 1=Enable)
/H[0|1]
Hex Only Display Control (0=Disable, 1=Enable)
/Ixx Set
iPort/AFM’s Own I2C Slave Address
/K[0|1|2|3]
I2C Bus Clock Rate Control (0=23, 1=86, 2=100, 3=400 KHz)
/M Menu
Display
/N([0|1|A|R])
iNterrupt Signal Monitor/Control/Status
(0=Disable, 1=Enable / A=Assert, R=Release / <CR>=Status
/O Open
I2C
Connection
/(*)Rn
Master Rx Message *=No Stop
/S(text)
Slave Tx Message
/(*)T(text)
Master Tx Message *=No Stop
/Un
Set
I2C
Bus Time-oUt in msec 0=Disable)
/V
Display Firmware Version (Major XX.XX Minor)
/X[...]...
Extended Cmds (See Prompt or User’s Guide)
/Y
Display Tx bYte Count
Interrupt Signal Control/Status
___
The INT signal allows the iPort/AFM to participate in INT master and/or slave
communications.
Command: /N0[CR]
Disable Monitor
/N1[CR]
Enable Monitor
/NA[CR]
Assert INT Signal
/NR[CR]
Release INT Signal
Response: *
Default Setting: /N0
, /NR
Open I
2
C Connection
This command activates iPort/AFM as an active device on the I
2
C Bus.
Command: /O[CR]
'Open I
2
C Connection
Response: /OCC[CR]
'Open Connection Complete
Default Setting:
Closed
