McAlpine Hussmann VLL726BL, Инструкция по установке и обслуживанию

Страница: 12 / 33

Page
12
ELECTRICAL INSTALLATIONS
The electrical installation shall:
• Meet existing regulations and safety codes,
• Have an electrical supply to the cabinet that is independent of other supplies,
• Be individually isolated,
There is a wiring diagram in the electric box of each cabinet.
If you require a replacement wiring diagram, please contact McAlpine Hussmann.
Please supply cabinet serial number with the request.
DRAIN INSTALLATIONS
Points to be aware of for cabinet drain installation:
• The cabinet should be correctly leveled,
• Water traps are factory fitted to the case,
• The installer should ensure that the drain then slopes to the drainage point,
• Drains may need insulating to prevent condensation dripping onto the floor,
PRE-START CHECK LIST
It is suggested that the following items be included but not limited to any pre-start
check of this cabinet.
• All electrical connections are secure and electrical tests completed.
• Refrigeration system has been pressure tested.
• Drain traps have been primed with water to seal and drain screens are fitted
where provided.
• Any loose material created during installation has been cleaned from the
cabinet. Pay particular attention to filings that may be caught under the
evaporator and fan panel seal. These could cause rust spots and pitting that
could permanently damage the stainless steel.
• All electrical, refrigeration and sensor penetrations have been sealed inside
and outside the cabinet. Including any penetrations through baffles or other
internal panels
• Fan panels seal correctly