22
9. Operation
Never point the exiting LED beams directly at the viewers and avoid emission at eye level.
Always pull the mains plug before filling the fog machine.
Never fill the fog machine with flammable liquids or add such to the fog liquid. Only ever use
suitable water-based fog liquids (the CONRAD range features suitable fog liquids).
Never tilt the fog machine. Fog liquid may leak out or enter the inside of the device and cause
damage there or injure the operator.
Make sure that no liquid enters the inside of the device when you are filling it with fog liquid. This
may cause damage to the device and potentially fatal electrical shock.
• Ensure that the mains plug is not plugged in.
• Unscrew the tank cover from the device and fill fog liquid into the tank (1).
• Fill the tank (1) no more than to the top mark 0.8 L of the fill level display (8).
• Then screw on the tank closure lid again.
• Plug the mains plug into a mains socket with a protective ground contact.
• Switch the device on using the ON/OFF mains switch (4). With the device on, the mains switch lights up and the
fog machine heats up.
• When the fog machine is switched on, the LED light effect works and the LED beams exit the LED light exit (3).
• To activate music control, turn the controller SOUND SENSITIVITY (7) clockwise (towards HIGH), until the light
effect changes in time to the music. If no control by music is desired, turn the SOUND SENSITIVITY (7) controller
counter-clockwise to the stop (LOW position).
• Heating up the fog effect takes approx. 4 minutes.
• Once the device has reached its operating temperature, the red indicators on the remote control are lit and the
device is ready for operation.
• Press the button on the remote control. The device emits fog from the fog exit opening (2) as long as you keep this
button pressed.
Ensure that the tank (1) never runs empty during fog operation. Should this happen nevertheless, turn
the fog machine off immediately using the ON/OFF (4)mains switch and let it cool down. Refill the
tank (1) after cooling.
If no fog emerges, the device is still warming up or reheating (the red indicators on the remote control are
not lit).
Slight fog lag after deactivation/disconnection of a device is normal and does not suggest a defect.
If you no longer require the device, disconnect the mains plug and let the device cool down.
Then empty the tank (1) if the device is not used again for an extended period. This prevents leaking of
fog liquid during transport or storage.
