WARNING BEFORE USE
To obtain proper operation of your stove, it is important to read this manual and
strictly observe directions for use and handling.
For combustion, use solid fuels like woods, briquettes and low-caloric coal. It is
forbidden to put explosive devices and materials into the firebox or on the plate. It is
forbidden to keep combustible materials in direct vicinity of the stove.
For proper combustion, in normal operating mode, draft in the chimney should be 10-
12 Pa. In case if draft is higher then 15Pa, flap should be installed into the chimney.
It is necessary on regular basis to ventilate room in which stove is located due to
inflow of fresh air necessary for combustion.
Stove parts get heated to high temperatures during operation and appropriate
attention is necessary during handling. Do no allow children to handle and play in
vicinity of the stove.
Only spare parts approved by the manufacturer may be installed on the stove. Do
not make any changes to the stove.
At the first firing up, slight smoking may occur, especially from the surface of the
plate. It is common appearance which originates due to combustion of deposits on
the plate surface (anti-corrosive protection, color, dust....). Room in which stove is
located should be ventilated during first firing up.
Do not allow parts of the stove to become extremely hot.
It is not recommended to install the stove onto collective chimney since it will cause
weak draft.
Do not connect gas device on the same chimney.
During burning, use protective gloves since door handles and vessels are hot.
DO NOT USE STOVE:
•
If stove is not connected to the installation
•
If there is not water in installation
•
If installation is defected
During installation, please follow national and local regulations for installation.
In case of non-observance of instructions, manufacturer does not bear any
responsibility for damages.
