130716© 12/16 Page
3
of
4
5. Install the
Driver Side and Passenger Side Frame Brackets
onto the
frame horns by first sliding the
5/16” Panel Nuts
onto the
Nut Plates.
Insert the plates
into the pockets on either side of the frame, the brackets
are installed on the inside of the frame rails. Using the supplied
5/16”
hardware
, attach each
Frame Bracket
by bolting through the factory holes
into the
Nut Plates
. Snug the bolts for now. Adjustment may be required
later.
Refer to Figures 6 and 7.
6. Pre assemble the
Light Bar
on the floor as shown. Be sure to place
the
Gasket
between the
Mounting Brackets
and the Tube. Install the
Panel Nuts
making sure that the threaded portion is towards the outside of
the Jeep. NOTE; If you plan to install lights, it is much easier to pre-wire
the bar at this step..
Refer to Figures 8, 9, and 10.
Figure 6
Figure 7
Figure 8
Figure 9
Содержание Off Camber Fabrications 130716
Страница 1: ......
