Страница 1: ......
Страница 2: ... Remove the 2 push rivets from the plastic Filler Panel between the bumper and the rad saddle using a Phillips screwdriver to remove the core and then pull the rivets out These will be reused Sometimes the core will spin without backing out If this happens try to pry up on the head of the rivet with a flat screwdriver while unscrewing the core This will help the rivet pinch the threads of the core...
Страница 3: ...h each Frame Bracket by bolting through the factory holes into the Nut Plates Snug the bolts for now Adjustment may be required later Refer to Figures 6 and 7 6 Pre assemble the Light Bar on the floor as shown Be sure to place the Gasket between the Mounting Brackets and the Tube Install the Panel Nuts making sure that the threaded portion is towards the outside of the Jeep NOTE If you plan to ins...
Страница 4: ...ar assembly by carefully sliding the Mounting Brackets through the holes previously trimmed in the Filler Panel Holding the Light bar assembly in place use the supplied 5 16 hardware and reach up from underneath and bolt the assembly to the Frame Brackets Do not tighten yet Refer to figure 13 10 Align the bar assembly by shifting the Frame Brackets Mounting Brackets as required Tighten all fastene...
