130716© 12/16 Page
2
of
4
2007-2017 Jeep JK Light Bar Kit
NOTE: 2012+ models require installation of a
Vacuum Pump Relocate Kit #132032
1.
Remove the factory splash guard by removing the push rivets. All
rivets are reusable so be careful removing them.
Refer to Figure 1.
2. Remove the Grill by removing the 6 push rivets across the top the Grill
shell. Keep the rivets, they will be reused. The lower edge of the Grill is
secured by clips. Give the Grill a good pull to release the clips. Unplug
the signal lights and set the Grill aside.
Refer to Figure 2.
3. Remove the 2 push rivets from the plastic Filler Panel between the
bumper and the rad saddle using a Phillips screwdriver to remove the core,
and then pull the rivets out. These will be reused. Sometimes the core
will spin without backing out. If this happens, try to pry up on the head of
the rivet with a flat screwdriver while unscrewing the core. This will help
the rivet pinch the threads of the core allowing removal. Once the rivets
are out, slide the panel towards the front of the Jeep, then rotate the rear
edge upwards 90 degrees and lift the panel out. This is tricky but it will
come out.
Refer to Figures 3 and 4.
4. Pull the wiring harness clips off the frame horns on both sides.
Refer to Figure 5.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Содержание Off Camber Fabrications 130716
Страница 1: ......
