Page 27
Alterations reserved
Operating Manual
Stand 01/2004
SBAP 46/72/82-ME ENG
5.4
Collector table
After the signature has passed the
pressing rollers the folded product will
fall onto the transport tape 1 of the
collector table 2.
The height of fall between the pressing
rollers and the collector table may be
adjusted at the adjustment grip 3 for
various products:
If you turn the adjustment grip
clockwise = you decrease the height of
fall; if you turn the adjustment grip
counter-clockwise = you increase the
height of fall.
>NOTICE< Unstable or thin products
require less height of fall; stable and
bulky products require more height of
fall.
After the pressing rollers the sheet
passes the photocell 4. Functioning
check: The diode will light up if
a sheet is passing the photocell.
Thereby, it will set the
transport tape 1 into motion. The
collector rollers 6 should grasp the sheet
before the tape stops again after it has
left the photocell’s range of detection.
For positioning of the collector rollers it
is necessary to loosen both knurled
screws 7.
You may laterally displace the
collector rollers if you loosen the
knurled screws 8. The smoother bars 9
may be placed forward if you loosen the
knurled screw 10.
Wrinkled sheets after the pressing unit will cut off the delivery through the default switch 11.
The delivery will also be cut off if it is connected to an MBO folding machine. However,
if the delivery is connected to a foreign machine only the SBAP 46 - ME will cut off.
The second photocell and the second default switch will be used for two-up production.
The speed of the transport tape and therefore the adjustment of short or extensive
formation of shingles may be adjusted through the potentiometer at the control cabinet.
