Page 14
10.
Directions for reversing the dryer door:
1. Remove the hinge hole covers and screws.
2. While supporting the door, remove 4 screws in the hinges that secure the hinges to the cabinet and
set the door down.
3. Move the following parts to the opposite side of the door: 2 hinges and 4 hinge screws, 4 door
screws, door strike and screw, inner door cover plate and screw.
4. Attach the door to the opposite side of the cabinet using the 2 counter sunk hinge screws.
(See figure 17.)
5. Replace the hinge hole covers to the opposite side.
11.
Directions for reversing the washer door:
1. Swing door fully open and support it while removing four hinge screws (which hold hinges to door
assembly).
2. Set door aside and transfer four color matched door screws to the opposite side of the door assembly.
3. Remove one screw holding top hinge to cabinet and one screw holding top hinge cover to cabinet
(opposite side).
4. Remove hinge and bracket from cabinet by moving them up and down to a position where they are
released.
5. Install hinge and bracket in swapped locations and drive screws to attach them securely to the
cabinet.
6. Compare top hinge and top bracket to bottom hinge and bottom bracket for correct assembly
position.
7. Repeat procedures 4 through 6 for bottom hinge to cabinet and bottom bracket to cabinet.
8. Support door in fully open position on hinge side and drive four screws to secure attach hinges to
door assembly.
9. Close door and check to see that clothes washer operates properly.
Figure17
Figure 18
