Page 9
To install…
1.
Carefully remove any packaging materials from the outside of the appliance. Set
aside two corner posts for installation. IMPORTANT: Notice that the hoses are tied
up with a shipping strap.
(See figure 1.)
The strap should not be cut or removed
until the machine is ready to be installed. FOR STACKED UNITS ONLY: After
shipping restraints (upper straps and lower straps) have been removed,
machine MUST be transported in the upright condition.
Cut both lower shipping straps where they wrap around
the crate bottom
(see figure 2.)
DO NOT BE ALARMED
as the tub will jump up when the last strap is cut
(see
figure 2a.)
2.
Lay two corner posts behind the appliance
and gently tip the appliance over on to its
back.
(See figure 3.)
3.
Pull loose straps from the bottom of the washer one at a time until all straps
have been removed.
(See figure 4.)
4.
Remove the crate bottom from the appliance.
(See figure 5.)
5.
Loosen the four adjustable washer legs and lock nuts enough to fit a wrench
on the lock nut.
(See figure 6.)
Carefully raise the washer back to an upright
position.
6.
At the installation site, locate the metal buckles attached to the shipping straps at back of washer.
Carefully cut away straps
(see figure 7)
near both buckles, completely removing both buckles from the
washer.
(See figure 7a.)
Figure 7
Figure 7a
Figure 1
Figure 3
Figure 6
Pull loose straps from back of
washer one at a time until all
straps have been removed.
Figure 2
Figure 4
Figure 2a
Figure 5
