Page 10
7.
Remove hose from the drain hose clip.
Place the drain hose in the drain facility. To change drain hose direction
or prevent hose from collapsing or becoming damaged, turn the end of
the hose while holding the base of the hose stationary.
(See figure 8.)
To prevent accidental dislodging secure the drain hose to the standpipe,
inlet hose or laundry tub with the tie strap provided in the parts package.
Be sure an air-tight connection is not made between the
drain hose and the standpipe. Standpipe must be at
least 24” high. 36” height is recommended.
(See figure 9.)
NOTE:
Caution must be always be exercised to avoid
collapsing or damaging the drain hose. For best
performance the drain hose should not be restricted in
any way, through elbows, couplings or excessive
lengths.
Route drain hose through the drain hose clip on the
rear wall of washer.
For installations where the drain hose cannot be con-
veniently elevated to at least 24”, the drain hose must be
supported by the drain hose clip on the back of the
washer.
Install one screen strainer and washer at the faucet end of each
fill hose. The dome on the screen strainer must point towards the
faucet.
(See figure 10.)
Attach the inlet hoses with the screen washer to the HOT and
COLD faucets. Tighten by hand until snug and then 2/3 of a turn
with pliers.
Do not overtighten. NOTE:
Accessory inlet hoses are
available in various lengths up to 10 feet.
Slide appliance into position.
Make sure the drain hose remains
routed straight through the drain hose clip without collapsing
or damaging.
NOTE: the appliance must be leveled on all
4 sides. To properly level a machine, the top cover and the
front panel must be securely fastened. A carpenter’s level
should be used on all 4 corners of the top. It’s a good idea to
check for level again after the first dozen washes and re-level
if necessary.
NOTE:
If drain standpipe is in excess of 5 feet above floor level, a drain hose extension kit will need to
be installed. If drain standpipe is in excess of 10 feet above floor level, a pump accessory kit may need
to be installed.
HOSE
RETAINER
Figure 8
Figure 9
Figure 10
