background image

450386 - 1

Maytag Co.

9

1.

Remove back guard.

2.

Remove drive belt.

3.

Disconnect wiring harness from motor.

IMPORTANT: If top pocket is being replaced, ductwork
on the side of the motor mount must be removed.

4.

Remove nuts and washers holding the motor mount to
the rear of the dryer and pull motor mount away.

5.

Remove the two left-hand nuts on the motor shaft
retaining the impellor.  Work the impellor free from the
motor shaft by means of a puller to prevent damage to
the motor shaft.

6.

Remove the bolts holding the motor and install on new
motor.

7.

Remove pulley from old motor and install on new motor.

5.

Lateral adjustment (viewing from the rear)

a. Loosening (by turning counterclockwise) the left-hand

adjustment bolt and tightening (by turning clockwise)
the right-hand adjustment bolt will shift the basket to
the right.

b. Loosening (by turning counterclockwise) the right-

hand adjustment bolt and tightening (by turning
clockwise) the left-hand adjustment bolt will shift the
basket to the left.

6.

Tighten and secure both adjustment bolts and jam nuts.

7.

Tighten the bearing box bolts.

Motor/Impellor Removal

  Notes ______________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

Содержание MLG-45











Отзывы: