450386 - 1
Maytag Co.
3
Table of Contents ________
List of Acronyms _____________________
DSI
Direct Spark Ignition
OSHA
Occupational Safety and Health Administration
IMPORTANT
You must disconnect and lockout the electric
supply and the gas supply or the steam supply
before any covers or guards are removed from
the machine to allow access for cleaning,
adjusting, installation, or testing of any
equipment per OSHA standards.
Please observe all safety precautions
displayed on the equipment and/or specified
in the installation manual included with the
dryer.
CAUTION
Dryer(s) should never be left unattended while
in operation.
“Caution: Label all wires prior to disconnection
when servicing controls. Wiring errors can
cause improper operation.”
«Attention: Au moment de l’entretien des
commandes, étiquetez tous les fils avant de
les débrancher. Des erreurs de câblage
peuvent entraîner un fonctionnement
inadéquat et dangereux.»
WARNING
Children should not be allowed to play on or
near the dryer(s). Children should be
supervised if near dryer(s) in operation.
Under no circumstances should the dryer door
switch(es), lint door/drawer switch(es), or heat
safety circuit(s) ever be disabled.
The dryer must never be operated with any of
the back guards, outer tops, or service panels
removed. Personal injury or fire could result.
The dryer must never be operated without the
lint filter/screen in place, even if an external
lint collection system is used.
FOR YOUR SAFETY
Do not dry mop heads in the dryer. Do not
use dryer in the presence of dry cleaning
fumes.
The dryers must not be installed or stored
in an area where it will be exposed to water
and/or weather.
The wiring diagram for the dryer is located
in the front electrical control box area.
Parts Locations and Removal ............................... 4
Computer Panel Assembly Removal ................... 4
Computer Board Removal ................................... 4
Lint Drawer Removal ........................................... 4
Door Switch Removal .......................................... 5
Top or Bottom Front Panel Removal ................... 5
Lint Door Switch Removal ................................... 5
Burner Hi-Limit Removal ..................................... 6
Idler Arm Removal ............................................... 6
Main 18” Pulley Removal .................................... 6
Basket Hi-Limit Removal ..................................... 6
Sail Switch Removal ........................................... 6
Ignitor Probe Assembly Removal ........................ 7
Flame-Probe Removal ........................................ 7
Rotation Sensor Removal ................................... 7
Basket/Tumbler Support Removal ...................... 7
Lateral and Vertical Adjustments ......................... 8
Tumbler Alignment (Lateral) ................................ 8
Motor/Impellor Removal ...................................... 9
