10
6.
Use masking tape to secure dryer door.
For direct-wired dryers:
WARNING
Electrical
S
hock Hazard
Disconnect power before servicin
g
.
Replace all parts and panels before operatin
g
.
Failure to do so can result in death or electrical shock.
1.
Disconnect power.
2.
Disconnect wiring.
3.
Make sure leveling legs are secure in dryer base.
4.
Use masking tape to secure dryer door.
Reinstalling the dryer
Follow the
“
Installation Instructions” to locate, level, and connect
the dryer.
TROUBLESHOOTING
First try the solutions suggested here and to possibly avoid the cost of a service call...
For additional recommendations, refer to your Installation Instructions or visit our website:
In U.S.A. www.maytag.com/help - In Canada www.maytag.ca
Dryer Operation
Dryer will not run
■
Has a household fuse blown, or has a circuit breaker tripped?
There may be 2 fuses or circuit breakers for the dryer. Check that
both fuses are intact and tight, or that both circuit breakers have
not tripped. Replace the fuse or reset the circuit breaker. If the
problem continues, call an electrician.
■
Is the correct power supply available?
Electric dryers require 240-volt power supply. Check with a
qualified electrician.
■
Was a regular fuse used?
Use a time-delay fuse.
■
Is the dryer door firmly closed?
■
Was the Power button firmly pressed?
Press and hold for 1 second.
No heat
■
Has a household fuse blown, or has a circuit breaker tripped?
The drum may be turning, but you may not have heat. Replace
the fuse or reset the circuit breaker. Electric dryers use 2
household fuses or circuit breakers. If the problem continues,
call an electrician.
■
Is the valve open on the gas supply line for gas models?
Unusual sounds
■
Has the dryer had a period of non-use?
If the dryer hasn’t been used for a while, there may be a
thumping sound during the first few minutes of operation.
■
Is a coin, button, or paper clip caught between the drum and
front or rear of the dryer?
Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.
■
Is it a gas dryer?
The gas valve clicking is a normal operating sound.
■
Are the four legs installed, and is the dryer level front to back
and side to side?
The dryer may vibrate if not properly installed. See the
Installation Instructions.
■
Is the clothing knotted or balled up?
When balled up, the load will bounce, causing the dryer to
vibrate. Separate the load items and restart the dryer.
Dryer displaying code message
■
“PF” (power failure), check the following:
Was the drying cycle interrupted by a power failure? Depending
on the length of the power outage, you may be able to resume
the cycle by simply pressing and holding START; otherwise,
press POWER and then start a new cycle.
■
“E” Variable (E1, E2, E3) service codes:
Call for service.
