![Maytag MGDB850WL - 29](http://html1.mh-extra.com/html/maytag/mgdb850wl-29-gas-dryer/mgdb850wl-29-gas-dryer_installation-instructions-manual_1748220014.webp)
14
6.
Hang door by placing screw heads into top slotted holes
of hinges and slide door down. Align bottom screw holes
in hinge and door. Install two bottom screws. Tighten
all hinge screws.
7.
Close door to engage door strike.
TROUBLESHOOTING
First try the solutions suggeste
d
here an
d
possi
b
ly avoi
d
the cost of a service call...
Dryer Operation
Dryer will not run
■
Has a househol
d
fuse
b
lown, or has a circuit
b
reaker
trippe
d
?
There may be 2 household fuses or circuit breakers for the dryer.
Check that both fuses are intact and tight, or that both circuit
breakers have not tripped. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
■
Is the correct power supply availa
b
le?
Electric dryers require 240-volt power supply. Check with
a qualified electrician.
■
Was a regular fuse use
d
?
Use a time-delay fuse.
No heat
■
Has a househol
d
fuse
b
lown, or has a circuit
b
reaker
trippe
d
?
The drum may be turning, but you may not have heat. Electric
dryers use 2 household fuses or circuit breakers. Replace
the fuse or reset the circuit breaker. If the problem continues,
call an electrician.
Dryer
d
isplaying co
d
e message
■
“PF” (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press and hold START/PAUSE to restart the dryer.
Try the following:
Check to see if a household fuse has blown or circuit breaker
has tripped. Electric dryers use two household fuses
or breakers. Replace the fuse or reset the circuit breaker.
Confirm the power cord is properly installed.
Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, consult a qualified electrician.
■
“F” Varia
b
le (F1E1, F2E2, F3E1, F3E2, F7E1, F3E6, F3E7)
service co
d
es:
Call for service.
■
For all mo
d
els without a
d
isplay win
d
ow:
If the “WET” in
d
icator light is flashing an
d
all other
d
isplay/
in
d
icator lights on the control panel are off:
Call for service.