Maytag CWG3100AA Series, Руководство по обслуживанию

Страница: 11 / 35

Troubleshooting Procedures
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power and gas before servicing, unless
testing requires power and/or gas.
©2005 Maytag Services
16026549 11
Problem Possible Cause Correction
Gas odor.
Gas leak ....................................................
Loose fittings .............................................
•
Check all gas connections for leaks
(see note below).
•
Check all gas fittings for leaks.
Oven slow to heat, poor
baking results, poor burner
ignition, flame too high or too
low. Pressure regulator.....................................
•
Test pressure regulator, see
"Testing Procedures."
Oven light does not operate.
Failed light bulb .........................................
Failed light switch ......................................
Failed light socket......................................
•
Replace bulb.
•
Test light switch contacts for
continuity. Replace if necessary.
•
Check for 120 VAC at the light
socket terminals. If no voltage is
present, check wiring.
Oven light does not
extinguish.
Failed light bulb .........................................
Failed light switch ......................................
Failed light socket......................................
•
Replace bulb.
•
Test light switch contacts for
continuity. Replace if necessary.
•
Check for 120 VAC at the light
socket terminals. If no voltage is
present, check wiring.
Never test for gas leaks using an open flame.
TESTING FOR GAS LEAKS: To test for a gas leak, apply a non-corrosive leak detection fluid to all joints and
fittings in the gas connection between the supply line, shut-off valve, and oven.
Include gas fittings and joints in the oven if connections were disturbed during
installation. Bubbles appearing around fittings and connections indicates a leak. If
a leak is present, turn off supply line gas shut-off valve, tighten connections, turn
on the supply line gas shut-off valve, and retest for leaks. When finished, wipe off
all residue.