background image

10

The preset settings should be correct for normal household 
usage. The controls are set correctly when milk or juice is as 
cold as you like and when ice cream is firm.

Wait at least 24 hours between adjustments. Recheck the 
temperatures before other adjustments are made.

The display screen on the dispenser control panel has a 
backlight, which will turn off automatically when the control 
buttons have not been used for 30 seconds or more. When 
the backlight is off, the first press of a control button will only 
reactivate the backlight, without changing any settings. Within 
30 seconds after the backlight has been reactivated, 
additional presses of control buttons will change the 
applicable settings.

Adjusting the Controls

To adjust the set points, press and hold the TEMP button for 
3 seconds. When adjust mode is activated, set points and 
adjusting information will appear on the display screen.

Refrigerator Controls

When adjust mode is activated, the “+” and “-” buttons on the 
right side of the dispenser panel adjust the refrigerator 
compartment temperature. The set point range for the refrigerator 
is 0°C to 7°C.

Press “-” to lower the set point.

Press “+” to raise the set point.

Freezer Controls

When adjust mode is activated, the “+” and “-” buttons on the left 
side of the dispenser panel adjust the freezer compartment 
temperature. The set point range for the freezer is -21°C to -15°C.

Press “-” to lower the set point.

Press “+” to raise the set point.

Press TEMP to exit adjust mode, or allow about 15 seconds of 
inactivity and adjust mode will turn off automatically.

Additional Features

NOTE: The display screen on the dispenser control panel has a 
backlight, which will turn off automatically when the control 
buttons have not been used for 30 seconds or more. When the 
backlight is off, the first press of a control button will only 
reactivate the backlight, without changing any settings. Within 
30 seconds after the backlight has been reactivated, additional 
presses of control buttons will change the applicable settings.
Fast Ice

The Fast Ice feature assists with temporary periods of heavy ice 
use by increasing ice production. 

Press FAST ICE to turn on the Fast Ice feature. When the 
feature turns on, the arrows above the “FAST ICE” icon on 
the dispenser display screen will blink. The Fast Ice setting 
will remain on for 24 hours unless manually turned off.

Press FAST ICE again to turn off Fast Ice.

When Fast Ice is active, the temperature display will not change. 
After 24 hours, the refrigerator returns to the previous temperature 
set points.
NOTE: If increased ice production is desired at all times, change 
the freezer control to a lower setting. Setting the freezer to a 
colder temperature may make some foods, such as ice cream, 
harder.
Temperature Display Always On 

This feature keeps the temperature display on at all times. 

Press and hold TEMP and LOCK at the same time for 
3 seconds to turn the feature on. 

IMPORTANT: To avoid unintentionally locking the dispenser 
or changing other settings, be sure to press both buttons at 
exactly the same time.

Press and hold TEMP and LOCK at the same time for 
3 seconds again to turn the feature off.

Door Ajar Alarm

The Door Ajar Alarm feature sounds an alarm when the refrigerator 
or freezer door is open for 5 minutes and the product cooling is 
turned on. The alarm will repeat every 2 minutes. Close both 
doors to turn it off. The feature then resets and will reactivate 
when either door is left open again for 5 minutes.
Disabling Sounds

To turn off all dispenser and control sounds, including the 
Door Ajar Alarm, press and hold ICE and FAST ICE at the 
same time for 3 seconds.

To turn all sounds back on, press and hold ICE and FAST ICE 
at the same time for 3 seconds again.

Style 2

Temperature Control Adjustment and Cooling On/Off 

The refrigerator and freezer control buttons are located on the 
dispenser panel. 

To turn cooling off, press and hold the LOCK and FAST ICE/COOL 
buttons at the same time for 3 seconds. Press and hold LOCK 
and FAST ICE/COOL again to turn cooling on. Your refrigerator 
and freezer will not cool when cooling is off.

CONDITION:

TEMPERATURE 
ADJUSTMENT:

REFRIGERATOR too cold

REFRIGERATOR Setting
1° higher 

REFRIGERATOR too warm 

REFRIGERATOR Setting
1° lower

FREEZER too cold

FREEZER Setting
1° higher

FREEZER too warm/too little ice

FREEZER Setting
1° lower

Содержание 23inch





















Отзывы: