MAYSER RADIOBAND 3G, Руководство пользователя, Страница: 21 / 24

8 Total reset
 Press PROG button on the receiver (1) until the R1 LED lights on (2).

Keep the programming PROG button pressed down and make a bridge with the “MR”
reset jumper (3).

The receiver will emit 10 warning sound signals (3), and then more at a faster
frequency, indicating that the operation has been carried out (4).

To exit programming mode, wait for 20 seconds or press PROG button on the receiver.
Two beeps will be heard.
9 Batteries
Storage
· Store the lithium cells in a cool, dry and ventilated area far from fires and heating sources.
· It is recommended the use of a non-combustible structure and keep adequate clearance between
walls and batteries.
· The maximum temperature suggested for the storage is +30°C.
· Higher temperatures are allowed but cause an increase in the self discharge of the battery and
speed up the process of passivation.
· In any case, never go over 100°C, as the batteries can break and cause a leakage.
· Arrange adequate protections to avoid possible damages to the batteries.
· Keep the batteries in their original packages until they are used.
· Do not expose the batteries directly to the sun light.
· Do not put a higher number of cartons one on another (respect what indicated).
· If in the same place are storage batteries with a total capacity >50,000Ah, it is suggested to
install an alarm for smoke and gas.
Usage
· If the battery is integral, store and handle with care (it is suggested to handle the batteries in a
ventilated place, do not smoke, eat or drink during the assembly).
· Do not expose at temperature higher than 100°C (it is recommended <85ºC).
· Avoid short circuit, crush, and exposition to heat sources.
· Do not disassemble the batteries or the battery packs, do not throw them in the fire, do not
perforate them, do not overheat or wet them.
· Material to avoid: water, oxidizing agents, alkalis.
Before disposing of the equipment, remove the batteries and dispose of them at a
proper place of disposal.
UM_320XXXX_RB3SYSTEM_EN_MAYSER_Rev00 Página 21/24