5
Once battery condition and voltage checks are satisfied,
the green ‘correct’ LED will illuminate on the side of the
smart cable, as shown below. The vehicle is now ready to be jump started; crank the engine within 30 seconds of
connection.
Upon successful starting the red and green LEDs will flash; the jump cable can now be disconnected. Remove the black
(-ve) clamp first, followed by the red (+ve) clamp. Leave the vehicle engine running for a period after disconnection to
allow battery to be recharged.
SMART CABLE STATUS LEDS AND FAULT CONDITIONS
Warning tone emitted with blinking green LED:
The vehicle battery voltage is below the minimum required threshold
of 6VDC in order for the device to successfully start the vehicle.
Warning tone emitted with steady red LED:
Correct connection polarity has not been observed. Remove clamps and
reconnect ensuring the red (+ve) clamp is connected to the desi12VDC connection point or positive post of the
battery and the black (-ve) clamp is connected to the vehicle chassis or negative battery post.
No LED illuminated, no warning tone:
The device cannot detect a connection to a vehicle. Remove and replace both
clips, rotating them slightly once clamped so as to remove any dirt or oxidization and thus ensuring a good contact.
CHARGING DEVICES VIA USB
A wide selection of portable devices like mobile telephones, tablets and portable media devices can be charged via this
device.
Connect the device you wish to be charged to the USB output socket using an appropriate cable and depress the ON/OFF
button on the side of the unit. The blue battery status indicator LEDs on the face of the product will illuminate and
charging will commence automatically.
8
7
