Smart Kettle
EN
15
USE
Please Note!
■
Before each heating process, ensure
that the On / Off switch is not blocked.
The kettle only switches off automat-
ically after the end of the heating
process if the On / Off switch is not
blocked.
■
Do not operate the kettle without
water or with less water than is re-
quired to reach the
MIN
marking. The
device could overheat. In this case,
the device switches off. Allow it to
cool down before it is fi lled and used
again!
1. Press the lid opener (
2
) to open up
the lid (
1
).
2. Fill the kettle (
10
) with at least 0.5
litres (
MIN
marking
7
) and no more
than 1.7 litres
(
MAX
marking
7
).
Insuffi cient water will cause the device
to switch off prematurely. If the
MAX
marking is exceeded, water could
splash out during the boiling process.
3. Flip the lid shut. It must engage.
4. Place the kettle on the base station (
6
).
5. Touch the fi eld
START / CANCEL
(
14
).
A beep is heard and the temperature
levels (
8
) and the current tempera-
ture (
9
) of the water appear on the
display (
4
).
6. Set the temperature level you want
(see “Functions” – “Temperature
Levels”) and start the heating process
via the fi eld
START / CANCEL
.
Please Note:
If the water is to be
kept at the set temperature after the
heating process, start the heating
process via the fi eld
KEEP WARM
(
15
)
(see “Functions” – “Keep-Warm
Function”).
The heating process can be
cancelled at any time via the fi eld
START / CANCEL
or by taking the
kettle off the base station.
7. As soon as the water has reached the
set temperature, you will hear three
beeps and the device automatically
switches off or switches to the keep-
warm function.
8. Take the kettle off the base station
and carefully pour the water into a
vessel.
CARE AND DESCALING
Please Note!
■
Regularly descale the device.
■
The device is
not
dishwasher-safe!
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
1. Completely empty the kettle (
10
).
2. Rinse out the kettle with a little mild
detergent and clear water.
Make sure
that no water gets into the contacts
on the bottom of the
kettle! Do not
immerse the kettle
in water!
This
could cause a short circuit.
3. Dry everything thoroughly.
4. Wipe down the base station (
6
) with a
dry cloth if necessary.
The kettle can be stored on the
base station when it is not being
used.
Descaling
The device should regularly be descaled.
Use a standard descaling agent for kettles
for descaling.
1. Pour a mixture of water and descaling
agent into the kettle (
10
) and heat the
water to 100 °C. To do this, follow the
instructions in the “Set-Up and Con-
nection” and “Use” chapters.
09971_Inlay_DE-EN-FR-NL_A5_V1.indb 15
09971_Inlay_DE-EN-FR-NL_A5_V1.indb 15
04.09.2020 13:09:45
04.09.2020 13:09:45