Page
4
of
4
To access Secondary Mode, or second flash pattern, Connect Green to +12V and White to (-)Ground.
While in Mode 2, use Yellow wire (+12V) to program the desired flash pattern (step 7).
Mounting Instructions:
The light comes with 3 mounting screws and 3 mounting screw covers.
Utilizing the proper tools, secure the light with the 3 screws into place. Before tightening the screws fully,
ensure that the light is mounted with the 'TOP' indicator at the top of the light. Once the proper alignment
is achieved, fully tighten the 3 screws. Use caution when tightening these mounting screws as over-
tightening may break the lamp. With the screws tightened, press the mounting screw covers onto the
screw holes.
Warning:
The plastic screw cover inserts are provided to make this lamp "tamper-resistant". They cannot
be removed once they are inserted. Do not insert them until the lamp is installed on the vehicle and
operation of the lamp is completely verified.
Note:
Maxxima
(a division of Panor Corp.) reserves the right to change any specifications, information and
instructions in this manual without notice. Panor Corp. makes no warranty of any kind with regard to this manual,
including but not limited to the proper and legal use and the fitness of this product for a particular purpose. Panor
Corp. shall not be liable for errors contained herein or for any incidental or consequential damages in connection with
the installation or use of this product as described in this manual.
