Page
2
of
4
Wiring Instructions
First, determine if the vehicle has a
dedicated
turn signal wire or uses a
common
wire for both stop light
and turn signal.
TABLE 1: 28 Flash Patterns
3-Wire Stop/Turn/Tail wiring (RED TURN SIGNAL)
If vehicle uses a common wire for both stop light and
turn signal, use the Red Turn Signal by connecting
the Red Wire.
4-Wire Stop/Turn/Tail wiring (AMBER TURN SIGNAL)
If vehicle has a dedicated Left & Right Turn Signal
wires, independent of the Stop Light, use the optional
Amber Turn Signal by connecting the White Wire
3-Wire STT Circuit
4-Wire STT Circuit
Step 1
Connect
Black
wire to vehicle Ground (- Negative)
Step 2
Connect
Brown
wire to vehicle Tail Light (+12V)
Step 3
Connect
Red
wire to vehicle Stop Light (+12V)
Step 4
(Optional) Connect
White
wire to vehicle Left or Right
Turn Signal (+12V)
Step 5
Connect
Blue
wire to vehicle Back-up Light (+12V)
Step 6
Connect
Green
wire “Flashing Warning Circuit” via a
user-supplied switch (+12V)
Step 7
Program Warning to the desired pattern with
Yellow
wire.
While the Green wire is connected to +12V, Hold
Yellow wire to +12V for 1 to 2 seconds to scroll to the next
flash pattern (See Table 1). If on a Single-Color pattern, Hold
Yellow wire for 3 to 5 sec to toggle to the alternate color (i.e.
from Amber to White). To reset to Pattern # 1, Hold Yellow
wire to +12V for 7+ seconds.
