OPERATION OF YOUR MAXXAIR SKYMAXX ROOFLIGHT
To open the Rooflight for ventilation, separate the screen
and shade by moving the pull bars in opposite directions.
Note: The screen/ shade opening and closing action is
manual. Depress the button on the Rooflight frame to
release the handle and raise the lid by using the handle.
Raise the lid to the desired opening using the slots in the
sides of the rooftop flange to position the lid. After
securing the Rooflight in the desired position, pull the
screen and shade together. The amount of screen versus
shade can be adjusted to your preference.
To close the SKYMAXX ROOFLIGHT, move the handle
from the slot and pull the handle toward the open side of
the Rooflight. Push the handle above the button which will
lock the Rooflight lid closed.
NOTE: THE ROOFLIGHT MUST BE CLOSED PRIOR TO
TRANSPORTING OR MOVING THE CARAVAN.
USER SERVICING INSTRUCTIONS
Cleaning of your MAXXAIR SKYMAXX ROOFLIGHT may
be achieved with mild soap and water only.
DO NOT USE
ABRASIVE CLOTH ON ROOFLIGHT COVER.
It is advisable when the Rooflight is open to keep the
screen and/or shade covering the Rooflight opening.
Should you have questions, please contact
AIRXCEL/MAXXAIR Customer Service at 316.832.4357
or [email protected].
FOR INSTALLATION OF SKYMAXX LX PLUS ROOFLIGHT
WARNING!
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
CAUTION!
Disconnect main vehicle power before
connecting 12 volt DC power to the
SKYMAXX
ROOFLIGHT
!
STEP 6
Insert the 12 volt DC power supply wires into the large
diameter hole in the interior flange, allowing 4 to 6
inches of wire to hang out. Note: Red wire from the wall
control and black wire from the negative terminal.
STEP 7
Insert the ceiling flange into the opening, lining up the
flanges.
STEP 8
Referring to the screw lengths in the table of STEP 5,
use the proper length screws depending on your roof
thickness to secure the ceiling flange to the rooftop
flange, taking care not to overtighten the screws to avoid
cracking or deforming the ceiling flange and rooftop
flange.
STEP 9
Optional: Install the screws to secure the ceiling flange
to the caravan ceiling. If the ceiling flange does not lay
flat to the ceiling, you may want to install screws to
prevent gapping.
STEP 10
Using the supplied wire nuts, connect the 12 volt DC
power supply wires to the LED light wires. Red wire from
the wall control to the red wire (pos) on the LED lights,
and the black wire from the negative terminal.
