INSTALLA
TION, OPERATION AND MAINTENANCE
INSTRUCTIONS FOR
MAXXAIR SKYMAXX LX 97000i, 97010i, 97100i, 97110i
READ AND SAVE THESE INSTRUCTIONS
NOTE:
Refer to Installation Instructions, Information and Operation Guides regarding the model you have purchased.
The
SKYMAXX Rooflight
installs into a roof opening of 700 mm x 500 mm (27.56 in. x 19.70 in.).
To determine if your roof opening is correctly sized, simply remove the interior ceiling garnish trim ring of your existing roof vent and
measure the ceiling opening or verify the opening is large enough by sliding the Rooflight interior ceiling flange into the opening.
The 97100i & 97110i Rooflight is designed for a minimum roof thickness 23 mm to 42 mm maximum. (0.90 inches to 1.65 inches).
The 97000i & 97010i Rooflight is designed for a minimum roof thickness 42 mm to 60 mm maximum. (1.65 inches to 2.36 inches).
The LED lighted Rooflight requires a minimum 12 Volt DC, 2 amp service. Confirm that the circuit you intend to use will accommodate
the additional load. Circuit must be fused and use appropriate gauge, stranded wire for electrical connections
.
NOTE: Wall Control for LED lights must be provided by installer.
NOTE: THE ROOFLIGHT MUST BE CLOSED PRIOR TO TRANSPORTING OR MOVING THE CARAVAN.
WARNING!
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
a) Use this unit only in the manner intended by AIRXCEL, INC. If you have questions, contact the manufacturer.
b) Before servicing or cleaning the unit, switch power off at service panel and lock the service disconnecting means
to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag, to the service panel.
CAUTION!
FOR GENERAL VENTILATION USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE
MATERIALS OR VAPORS
.
P/N: 11C90029i 10-2019
