Step 7
The interior Garnish Trim Ring must be
trimmed to fit your particular RV roof thickness.
To accomplish this, measure the distance from
the vehicle ceiling surface to each corner of the
MaxxFan Control Plate.
Most RV roofs have some slope, so measuring
each corner is necessary. The Garnish ring
should be cut 1/4 to 1/2 inch longer than the
dimensions measured at each corner.
7
7A
- After adding 1/2 inch more, a line is drawn
on the outside of the Garnish Ring at 4 inches.
7B
-
Connect all four corners with a line at the
required dimension and trim accordingly.
Step 8
Complete the installation by placing any excess
wiring to the inside of the roof opening and sliding
the Garnish Ring into position. Fasten in place
using the four painted flat head screws provided.
For additional information about your
MaxxFan
, please read the enclosed
“Information and Operating Guide”.
A
B
Congratulations
!
You have successfully
completed the installation
of your new
MaxxFan
.
If there is anything we can
do for you, please visit
our website
www.maxxair.com
or call us at:
(800) 780-9893
8
In the picture shown to the left (#7), the installation,
(example only), measures 3 and 1/2 inches from
the ceiling to the Control Plate. Go to 7A & 7B.
Ceiling
Control
Plate
Garnish
Ring
(Measurements are an example for illustration purposes only.)
