All of the other included Bolts and Nuts are
of the same size and are used to assemble
the various plastic panels of the Tumbler
together.
First connect the Sliding Door Panel to the
two Side Panels using 4 Bolt/Nut sets.
For easier Panel assembly, stand the as-
sembled Side Panel/Sliding Door Panel
vertically as shown below.
Model 80699 Page 4
Side Panel
Note: Connection is made where two
triangle marks meet
Sliding Door
Panel
All Panels are of the same design. Attach
this Panel first to the Sliding Door Panel.
Note: See 2 tabs inside each Panel. These
tabs fit inside the rectangular opening of the
adjoining Panel. Connect each Panel using
7 Bolt/Nut sets.
Next, assemble this Panel.
Then, assemble one more Panel.
Tab
Tab
Assembling the flat, center Divider inside
the Tumbler:
In Photo below, see how the Divider rests
between the 2 tracks on inside of each
Panel. Slide Divider in place.
This is a good time to make sure that all
previosly assembled Bolts/Nuts are tight,
before adding the final 3 Panels to close up
the Tumbler.
After adding each of last 3 Panels, double
check that the Divider is resting in the tracks,
before tightening the Bolts/Nuts.
Attaching last Panel to Sliding Door
Panel:
In Photo below see how lip of last Panel
slides underneath edge of Sliding Door Pan-
el, before Bolts/Nuts are tightened in place.
Slide Divider
in place
Tracks
Lip slides
underneath
edge of Sliding
Door Panel
