maxwatt MX4500iS, Руководство оператора

Страница: 36 / 52

33
SPARK ARRESTOR MAINTENANCE
Inspect and clean the spark arrestor every 100 hours of operation.
The spark arrester is located outside the muffler, which gets very hot during operation. Allow the engine to
cool completely before servicing the spark arrester. To inspect and clean the spark arrester:
1. Remove the two screws, and remove the tail pipe and spark
arrester.
2. Use a brush to remove carbon deposits from the spark arrester
screen. Be careful to avoid damaging the screen.
The spark arrester must be free of breaks and tears. Replace
the spark arrester if it is damaged.
3. Install the spark arrester in the reverse order of removal. Fig. 22
DRAINING THE FUEL TANK / CARBURETOR
To help prevent gum deposits in the fuel system, drain the fuel from the tank and carburetor
before storing.
1. With the help of another person, place the
generator on an elevated platform such as a
table or desk.
2. Unscrew the maintenance cover knob, and remove the
cover from the side panel.
Maintenance Cover
To draining fuel tank:
3. Make sure that the fuel
switch to turned to
“ON”.
To draining carburetor:
3. Make sure that the fuel
switch to turned to “OFF”, at
this position, the fuel valve is
turned OFF so that only the
fuel left inside the carburetor
will be drained out.
Knob
4. The carburetor can be accessed between the engine and the air filter (Fig. 23). Locate the
transparent tube from the carburetor (Fig. 24) that extends down through the base plate
of the generator.
5. Prepare an approved petrol-storage container and direct the end of the drain tube into
the container.
6. Open up the carburetor drain screw (Fig. 24) with a at-head screwdriver (not included)
and drain out any petrol that has built up inside the carburetor through the drain tube
into the approved petrol-storage container.
Carburettor