Maxtec SHOCKBLAZE, Инструкция по эксплуатации, Страница: 21 / 42

braking surface is worn and it is necessary to replace the
rim.
After making all these checks , if you note any anomalies or
if you have any doubt about the status of the wheels, con-
tact your dealer to get assistance.
WARNING/IMPORTANT:
Dirt or grease make the brake inefficient. So be sure that
the rim brake surfaces are clean. If not wash them using
soap and water and then give them a rinse or use a soft
cloth dampened with a delicate degreasing substance sui-
table for paint.
PEDALS
(assembling instructions)
The pedal marked with the letter R has to be screwed
clockwise on the right crank while the pedal marked with
the letter L has to be screwed anticlockwise on the left
crank.
The pedals have to be hard fastened using the right key.
Start screwing by hand and
then fasten very hard using the
key (with 35/40 Nm).
Turn and move the pedals
right and left and up and down
using your hands to be sure
that the pedal bearings are
efficient.
If the bearings are too loosen
or too rigid, contact your dealer
for the technical assistance.
It is necessary to wear special
shoes equipped with shoe plates in order to block your feet
on the pedals directly through a locking system (Fig. 25).
In this case insert the front side of the shoe plate in the front
side of the pedal and press down to fix your foot on the
ENGLISH
59
Fig. 25
LIBRETTO_Layout 1 25/10/10 18:44 Pagina 59