Maxtec SHOCKBLAZE, Инструкция по эксплуатации, Страница: 20 / 42

58
Use and instructions book
to the following tightening: front 40 Nm and rear 40 Nm.
Then check again.
Particularly verify if the nuts fixing the wheels to the threaded
hub axle is well fastened or if the quick release lever that
allows to put the wheel in and off without using any equip-
ment is well closed (Fig. 8). Normally the bicycle are equip-
ped with quick release hubs.
WARNING/IMPORTANT:
Check if your bicycle wheels are well fixed to the frame and
fork. If not the wheel could loosen and suddenly come off,
this could be very dangerous for you and other people.
The quick release has to be adjusted and fastened correc-
tly as described here below.
Check the spokes, they could be broken or unloosen.
Lift the front side of your bicycle and try to move right and
left the rim to check if the hub bearings are loosen.
If the hub makes a strange noise, check it turning the
wheel.
Check the wear limit of the rims verifying the wear indica-
tors on the braking surface marked like a continuous track
around the rim. If the track is not evident, it means that the
Fig. 24
LIBRETTO_Layout 1 25/10/10 18:44 Pagina 58