MaxPro PROFESSIONAL 113-0101, Руководство пользователя

Страница: 11 / 39

8 GB
Transport se tting( figu re 9 )
When transport the machine, only carry the machine in transport posi tion . If not carried in transport
position parts f rom the machine can be damaged.
- Unlock the transport position, firmly grip the handle (1) and press the handle(1) a li ttle downwards, pull
out the transport locking knob (15) out. The handle (1) will now raise by spring force. There for always
guide the handle(1) when the lift t o high position.
- Lock in transport position, firmly grip the handle (1) and press the handle(1) downwards till it maximum
pos ition, push the transport locking knob (15) in , if the lock knob (15) not can be pushed in far enough
then release the handle (1) a li ttle in upwards dir ection while s till pushing the transport locking knob (15)
un til the handle will loc ked.
Depth limit er( figu re 10 )
The depth limiter prevents the cut-o ff wheel from cont acting the workbench or floo r. When a new wheel is
installed or when the cu tting wheel not can cut trough the material , set the depth limiter as followed.
-Increase the depth limita tion, loosen the lock nut (17a) a so far that the depth limiter bold(17) can be set.
press the handle (1) downwards till the desired depth has been reached. Now turn out the depth limiter
bolt (17) till the stop plate (17b) touch the limiter bolt (17). Now secure the lock nut (17a).
-decrease the depth limita tion, loosen the lock nut (17a) a so far that the depth limiter bold(17) can be set.
Turn in the depth limiter bolt a few rota tions and press the handle (1) downwards till the desired depth has
been reached. Now turn out the depth limiter bolt (17) till the stop plate (17b) touch the limiter bolt (17).
Now secure the lock nut (17a)
OPERATION
- Hold the handle (1) firml y. Switch on the tool and with the switch bu tt on (3) wait un til the wheel a tt ains
full speed, if desired the switch can be locked by pressing the lock on bu tt on (4)
-Lowering the cu tting wheel gently into the cut by pressing at the handle (1)
-When the wheel contacts the workpiece, gradually bear down on the handle to perform the cut.
-When the cut is completed, switch o ff the tool by release the switch on/o ff bu tt on (3) in case the lock on
function is used only p ress and release the switch on/o ff butt on (3) without pressing the lock bu tt on (4)
- WAIT UNTIL THE WHEEL HAS COME TO A COMPLETE STOP before returning the handle to the fully
elevat ed position.
Caution
• Proper handle pressure during cu tting and maximum cu tting e fficiency can be determined by the amount
of sparks that is produced while cu ttin g. Your pressure on the handle should be adjusted to produce the
maximum amount of sparks. Do not force the cut by applying excessive pressure on the handle. Reduced
cu tting e fficienc y, premature wheel wear, as well as, possible damage to the tool, cut-o ff wheel or
workpiece may result.
CLEANING AND MAINTENANCE
Important! Maintenance, cleaning and repair work may only be carried out a ft er the machine is protected
against accidental st arting by pulling the mains plug.
Repair and maintenance work on the electrical system may only be carried out b y a qualified electrician.
A qualified repair technician must perform any tool service or repair. Service or maintenance performed by
unqualified pe rsonnel could result in injury. Use only iden ti cal replacement parts. Use of unauthorized