MaxPro PROFESSIONAL 113-0101, Руководство пользователя

Страница: 10 / 39

7 GB
Preparation off cut of job
- Before operating the machine ensure the machine is placed on a flat and stable surface.
- For safety reasons be sure that all the functions can be operated as stated in this manual, before starting
cutting, manually check if the all functions works properly .
- Always be sure that the work piece is secured and supported on a proper way.
- Always be sure that the tool is switched off and unplugged before adjusting or checking function on the
tool.
Securing workpiece (figure 1)
- By turning the vise handle(8) counterclockwise and then flipping the vise nut (7) to the front direction (“o”),
the vise (6) is released from the shaft threads and can be moved rapidly in and out by pulling and pushing
the vise handle (8).
- To secure workpieces, push the vise handle (8) until the worpiece contacts between the Vise clamp(6) and
the fence (9)and flip the vise nut (7) to the rear direction (“c”) and then turn the vise handle (8) clockwise
to securely retain the workpiece.
- Long workpieces must be supported by blocks of non-flammable material on either side so that it will be
level with the base top, ensure the supports are not higher in height than the underside of the worpiece.
Caution
Always set the vise nut to the right position when securing the workpiece. Failure to do so may result in
insufficient securing of the workpiece. This could cause the workpiece to be ejected or cause a dangerous
breakage of the wheel and can lead to enjury.
Setting for desired cutting angle (figure 2+3)
To change the cutting angle of the machine, loosen the two hex bolts (9a+9b) which secure the fence (9).
Move the fence(9) to the desired angle (0° - 45°) and tighten the hex bolts (9a+9b) securely.
Interval between vise and guide plate (figure 4+5)
The original spacing or interval between the vise (6) and the Fence (9) can be adjusted if your workpiece
requires this.
proceed as follows to change the spacing or interval.
- Remove the two hex bolts (9a+9b) which secure the guide plate.
- Move the fence (9) as shown in the figure 5 and secure it using the hex bolts (9a+9b).
Removing or installing cut-off wheel ( figure 6 till 8 )
- To remove the wheel, raise the safety handle (1) . Press the spindle lock (11) so that the wheel cannot
revolve and use the provided wrench to loosen the hex bolt by turning it counterclockwise. Then remove
the hex bolt (10a), outer flange (10b) and wheel (10) Do not remove the inner flange !.
- To install the wheel follow the removal procedures in reverse.
After install a new wheel manually turn the wheel (10) a few rotation by hand ( not switch the machine on!)
and ensure the cutting wheel freely rotate and the cutting wheel not wobbly.