20
Chapter 5 Operation Guide
2-Quick Wiring Guide
1.The wiring method in the figure is the six wires that the laser must be
connected to, if the analog mode is not used.The two wires of the analog
quantity can be omitted.
2."Enable input" should be given a high level of 24V after power on, if not
connected, the host computer will have an enable fault alarm.
3.It is better to add a magnetic ring to the external control line, which will have a
certain anti-interference effect.
3-Front Panel Indicator Color
ACTIVE light Green: laser on
No light: the laser is not turned on
ALARM light Red: Laser alarm
Off: laser is normal
POWER light Green: The laser is powered on Off: The laser is not powered on
4-Software Operation Instructions
1
、
Connect The Laser
The standard serial to USB cable is used between the computer and the laser.
Customer first installs the serial to USB cable driver. This driver is provided by
the manufacturer . As shown in Figure 1, the completed installation.
