26
Chapter 5 Unpacking Guide
Chapter 6
Operation Guide
1 - Notice
Caution:
◎
Please refer to Section "Detail Specification Table" for proper electrical power.
◎
Refer to Section "General Safety Instructions" for inspecting whether
the configuration environment of peripheral work of the laser meets the
requirements.
2 -
Electrical Power Connection
The laser power input line needs to be connected to three-phase four-wire AC.
Make sure that the live wire is properly connected according to the wire mark
and the ground wire is well connected. Poor contact of the ground wire may
cause potential damage to the laser.
For ensuring the safety feature, Maxphotonics recommends you connect a 32A
circuit breaker (air switch) in series between the power supply unit and the laser.
This electric power shall be in close proximity to the power supply unit of the
equipment and can be easily disconnected.
Refer to Section "Detail Specification Table" to determine your electrical
specification if you have any problem about wiring.
